Kreg PRS2100 Precision Benchtop Router Table User Manual download pdf (Page 8)

Benchtop Router Table Assembly Instructions

Step 10

Assemble the bit guard (#30) using two ¼-20 x 1¼" T-bolts (#31), two

spacers (#32), two ¼" brass ﬂ at washers (#28), and two T-knobs (#29),

as shown. Slide the T-bolt heads into the T-slot at the top front edge of

the fence extrusion and tighten the knobs.

Step 11

Assemble the ¼-turn fence locks using the fence-lock bases (#33), fence-

lock handles (#34), ¼-20 x 2½” Phillips panhead machine screws (#35) and

fence-lock anchors (#36). Slip the machine screws through the handles and

bases and drop the handle/base/machine screw assemblies through the

holes in the base ﬂ ange of the fence extrusion. Thread the machine screws

into the fence-lock anchors until just the tips of the anchor “ﬁ ngers” engage

the notches in the bases. [Because the anchor ﬁ ngers engage the base

notches, the anchors can’t turn and bind in the table-top slots or change the

fence-lock tension.]

Note: When using the fence with a table top thinner than 1 ⅛”, carefully trim the

ends of the anchor ﬁ ngers so they don’t bottom out in the cam-post notches.

Step 12

Mount the assembled fence on the router-table top by dropping the fence-

lock anchors (#36) through the key holes in the table top. D-shaped holes

in the fence automatically orient the fence-lock bases. Position the fence-

lock handles pointing away from the fence and angled 45 degrees to the

right [viewed from the back of the fence]. This is the unlocked position for

the handles. Slide the fence forward, engaging the fence-lock anchors in

the table-top fence slots. To adjust fence-lock tension, rotate the handles

¼-turn clockwise [locked position]. Tighten the machine screws (#35) with

a screw driver until the clamps are tight enough to hold the fence in place.

Now when you rotate the handles ¼-turn counterclockwise to release the

fence, it should move freely.

Step 13

To store the jointing rods (#37), slide them into the round channel at the

back edge of the base ﬂ ange of the fence extrusion. For instructions on

how to use these rods for jointing on your router table, see JOINTING

under the section USING YOUR ROUTER TABLE.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

Kreg PRS2100 Precision Benchtop Router Table User Manual Page 8