Kreg KKS1020 Klamp Trak User Manual download pdf

Logo on white, gray

or any lighter shade

when printing color

Logo on Pantone

2945 or any darker

shade when printing

color

Logo on white

or light shade when

printing grayscale

Logo on black or

dark shade when

printing grayscale

Klamp Trak

Instructions

ITEM# KKS1020 - Klamp Trak

1. Rout into edge of workbench

(page 1)

2. Add a 3/4” surface to the top of your workbench

(page 2)

3. Place between two staggered pieces of 3/4” plywood

(page 3)

Getting Started

There are three main methods for installing Klamp Trak™ in your workshop. In all three methods, your goal will be to construct an opening

with the same (or slightly larger) dimensions as the Klamp Trak™, directly below your intended work surface. This will allow the trak to sit

flush-with or slightly below the main surface, keeping your work surface clear of obstacles. Klamp Trak™ dimensions can be found in the

diagram on page 5 of this instruction manual..

Below are the three methods to choose from. Depending on how you intend to use your Klamp Trak™,

determine the best choice for your specic situation.

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - Klamp Trak

Logo on white, gray or any lighter shadewhen printing colorLogo on Pantone 2945 or any darker shade when printing color Logo on white or light shade

Page 2

WarningWARNING: Do not rout this Trak into material less than 1.5” deep. Doing so could result in bolts being pulled through the surface or related

Page 3

• Add a ¾” surface to the top of your workbench. Good if you would like to eventually replace the top of your workbench or return it to

Page 4

• Place between two staggered pieces of ¾” plywood. Good if you wish to create a new and affordable workbench from scratch. 1. Place th

Page 5 - Inserting Bolts

Inserting BoltsRegardless of the method you chose to install the Klamp Trak™, the next step is to secure the trak to the opening that you have just cr

Page 6

If you are using flat head bolts, you must first counter-sink the underside of each hole, and then insert the bolt up through the bottom of each hole.

Page 7

TipsTIP: If you choose to use flat-head bolts, inserting up through the bottom of each hole, be sure to use the correct length of bolt. The must be

Page 8 - Klamp Trak Specications

2.250”0.695”0.375”0.375” 1.500”0.500”Klamp Trak SpecicationsTMPage 7 Klamp TrakTM Instructions