Kreg Precision Band Saw Fence User Manual download pdf (Page 6)

Assembly

Slip a washer over one mounting bolt, insert the bolt through the right-

hand rail slot, and thread it into the right-hand saw-table hole. Snug, but

do not tighten the bolt. Slip a washer over the other bolt. Holding the rail

in position, insert the bolt into the appropriate rail slot and thread it into

the saw-table hole. Snug the bolt. Align the rail parallel to top surface of

the saw table and with the top edge of the rail

⁄16" below the bottom of

the miter-gauge slot. Tighten the bolts.

Tip

Set the blade of your combination square to the miter gauge slot depth

plus

⁄16". Then use the square to position the top edge of the mounting

rail at each mounting bolt.

Loosely fasten the rail at the right-hand end, then rotate

the rail into position and secure the left-hand end.

Install the Mounting Rail

⁄16"

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

No comments

Kreg Precision Band Saw Fence User Manual Page 6